STYRN Studio · 3D Home Design
3D Home Design Software for Residential Builders
STYRN generates an interactive 3D building model directly from the 2D floor plan. Walls are raised at their real thickness, openings are cut as actual voids, and every level is stacked as drawn — so you can check the design without redrawing it.
How it is built
The model is the drawing, viewed in three dimensions.
Nothing is exported and nothing is remodeled. Change a wall in the plan and the building changes with it.
01
Walls extruded from the drawing
Every wall is raised at its modeled thickness and mitred where it meets another wall, so outside corners close cleanly and a junction never shows a gap.
02
Real door and window openings
Each opening is a void cut through the wall at its true width, height and sill, with a door leaf or glazing drawn inside it. Nothing is pasted onto a flat facade.
03
Every level, stacked in order
A multi-level plan is modeled as it is drawn: each floor at its own elevation, with floor slabs over the rooms and open-to-below areas left open.
04
2D, 3D and Split View
Switch between the plan, the generated model, or both side by side. The 3D pane is a read-only view of the drawing — edits stay in the 2D editor, where dimensions live.
05
Orbit, pan, zoom and presets
Inspect a corner or the whole massing with standard camera presets, Fit and Reset, and layer toggles for walls, floors, doors, windows and the roof. You can also filter to a single level.
06
Live from the 2D edit
The model is derived from the drawing rather than stored beside it, so moving a wall or resizing an opening changes the 3D view as you work — no export step, no second model to keep in sync.
07
Roof visualization
Roof sections are modeled with their planes, ridges, hips and valleys, and can be viewed over the building with the option to see through them while inspecting the interior. The roof system is in development and still being corrected.
What it is
Automatic modeling, honestly described.
An accurate model for design review is genuinely useful. A rendered picture is a different tool — and we do not claim to be one.
What STYRN does
- A geometric model derived from your 2D floor plan
- Walls extruded at their modeled thickness and mitred at junctions
- Real door and window voids, with leaves and glazing
- Every level stacked by ceiling plus floor assembly
- Roof planes with ridges, hips and valleys (roof design is in development)
What it does not do
- A photorealistic render — no materials or image output
- Structural engineering or load calculations
- Construction-ready or permit drawing sheets
- Automated building-code compliance
- An editable 3D workspace — edits happen in the 2D plan
2D · 3D · Split
Draw on one side, check on the other.
Split View keeps the plan and the building side by side. The plan stays the source of truth: dimensions are edited there, and the model follows within the same session.
- Camera presets, orbit, pan, zoom, Fit and Reset
- Layer toggles for walls, floors, doors, windows and roof
- Filter the view to a single level
- A read-only view, so a measurement cannot be nudged by accident
Roof design is in development. Gable, hip, shed and flat sections carry pitch, overhang and thickness, and the model reports ridges, hips and valleys — but the roof geometry is still being corrected, so treat it as an evolving capability rather than a finished deliverable.
FAQ